Garage door repair in South Jordan and the southwest valley from 7 AM to 10 PMCall us: (801) 850-0069

Garage Door Opener Repair

Board, gear and sensor repairs — across South Jordan, Riverton, Herriman, Draper, West Jordan, Bluffdale, Sandy, Copperton.

When an opener acts up, the fault sits in one of six places: power at the unit, the controls (wall button, keypad and remotes), the circuit board, the drive (gear, belt or chain), the travel and force settings, or the safety sensors. We check them in that sequence, which keeps the repair aimed at the failed part and away from a hopeful swap.

Before blaming the motor, we check the door. DASMA's guidance is that a door that takes two hands to lift is out of balance and the answer is a spring or cable repair, because openers are designed for doors that already float. We also check the part that confuses homeowners most: the photo-eyes. Clopay notes that dirty or misaligned sensors make a door reverse before it closes, and DASMA's six-inch rule keeps the beam low enough that a child or pet cannot pass beneath it.

Common boards, gears, capacitors, sensors and remotes ride on the truck for the major brands. When a unit is past repair, we say so and quote the replacement next to the repair, so you can compare the two.

Opener Problems We Track Down

  • The remote only works from the end of the driveway
  • The motor hums or clicks but the door stays put
  • The door reverses at the same spot every time
  • A grinding or ratcheting sound from the motor head
  • Nothing happens after a thunderstorm or power flicker
  • The sensor lights blink with nothing in the way

🏔️ The Wasatch Front Factor

Two local habits cause a lot of opener calls. July and August bring monsoon thunderstorms to the south valley, and a power surge can leave a logic board dead while the rest of the unit is fine. In spring and fall, windblown dust from the Great Salt Lake bed settles on sensor lenses, and a film of dust can look exactly like a misaligned eye. Utah State University recorded the airport wind doubling from about 11 to 22 mph during one such dust event. We clean and test before we replace anything.

How We Handle It

Step 1

Power and controls

Outlet, wall button, remotes and keypad are tested first, because a weak remote battery is the simplest fix.

Step 2

Door versus opener

The opener is disconnected and the door lifted by hand, to rule out a spring or cable problem posing as a motor failure.

Step 3

Component testing

Board, capacitor, gear or belt, limits and sensors are checked in turn, and the failed one is named and priced.

Step 4

Safety verification

Reversal on contact, the photo-eye beam and the travel limits are set and proven before the unit is left running.

Technician beneath a raised wood-look garage door, seen from inside the garageTwo technicians heading up a driveway toward a gray double garage door

What Opener Repairs Cost

Garage Door Opener Repair by brand and model
Quoted on site
Diagnostic Service Call $0 with a completed repair
$0

Parts differ widely between brands and models, so the repair is priced after testing and before any part is swapped.

Garage Door Opener Repair — FAQs

Why does my garage door opener light blink and the door won't close?
A blinking light with a door that won't close usually points to the safety sensors: misaligned eyes, a dirty lens or a damaged wire. We wipe the lenses, realign the two eyes so they face each other, and check the wiring if one stays dark. Blink codes differ by brand.
What makes the door bounce back up right before it closes?
The opener thinks something is in the way. That is usually a misaligned or dirty photo-eye, or a down limit set too short. Clopay advises wiping both sensors clean and making sure they face each other; if the reversal continues, call us.
How high should the garage door sensors be mounted?
No higher than six inches above the floor. DASMA sets that limit so a child or pet cannot slip under the beam undetected, and recommends testing the photo-eyes monthly by blocking the beam while the door closes.
Is an older opener worth fixing, or is it time to replace it?
Repair a newer unit with one failed part, such as a gear or a board. Replace an opener that predates photo-eyes or has several worn systems. DASMA notes that openers made for the U.S. from 1993 onward must include a second safety reversing feature such as photo-eyes.
Can a power surge kill a garage door opener?
Yes. A surge can burn out the logic board or capacitor while the motor and rail stay sound. We test both before we recommend replacing anything, and we price a board repair next to a new unit so you can see the difference.
Contact

Reach the Bonneville Team

The line is answered 7 AM to 10 PM. Prefer to write? Use the form with a short note on the problem and we will ring you back.

☎ Call (801) 850-0069 View on Google Maps

Ask for a call back

We use these details only to reply to you. Privacy Policy.

☎